Single mechanical seal, balanced, independent of the direction of rotation with multi-spring configuration. The MTM180 Series represents the mechanical seal with the most reduced axial dimensions. Thanks to the possibility to be configured with all the stationary rings, it is interchangeable with all the most famous mechanical seal on the market today. Source of proud, it has been defined by the industry as “Universal Seal”. Made according to UNI EN 12756( ex DIN 24960)it is available in different materials including plastics such as PEEK and DIFLON. Thanks to its design the seal is able to resist up to 64 bar of pression.
d = from 12 mm (0,47″) up to 200 mm (7,87″) ***
p max = 64 bar (928 psi)
T = from -40°C (-40°F) up to ‘+220°C (+428°F)
v max = 32 m/s (105 ft/s)
Vacuum = 0,5 bar (7,25 psi)
Axial movement : +/-0,5 mm
***Avaiable in inches too
Rotary face:
resin/antimony carbon (G2/G3)
silicon carbide (S1)
tungsten carbide (T)
Other…
Stationary face:
silicon carbide (S / S1)
tungsten carbide (T / T1)
Other…
NBR / Nitrile (N)
EPDM / Ethilene propylene (E)
FKM / Viton (V)
FFKM perfluoroelastomeric (K),
Other…
Water and sewage water pumps
Process industry
Chemical industry
Refinery industry
Pharmaceutical industry
Power plant industry
Centrifugal pumps
Marine pumps
Fuel oil pumps
Lube oil pumps
Screw pumps
Gear pumps
Lube compressors
Low solids content
High viscosity
Hot applications
Special rotating equipment
1. Rotary case
2. Grub screw
3. Spring
4. Rotary ring
5. Screw
6. Stationary ring
7. O-ring
8. O-ring
9. Cuff
Single mechanical seal, balanced, independent of the direction of rotation with multi-spring configuration. The MTM180 Series represents the mechanical seal with the most reduced axial dimensions. Thanks to the possibility to be configured with all the stationary rings, it is interchangeable with all the most famous mechanical seal on the market today. Source of proud, it has been defined by the industry as “Universal Seal”. Made according to UNI EN 12756( ex DIN 24960)it is available in different materials including plastics such as PEEK and DIFLON. Thanks to its design the seal is able to resist up to 64 bar of pression.
1. Rotary case
2. Grub screw
3. Spring
4. Rotary ring
5. Screw
6. Stationary ring
7. O-ring
8. O-ring
9. Cuff
Rotary face:
resin/antimony carbon (G2/G3)
silicon carbide (S1)
tungsten carbide (T)
Other…
Stationary face:
silicon carbide (S / S1)
tungsten carbide (T / T1)
Other…
NBR / Nitrile (N)
EPDM / Ethilene propylene (E)
FKM / Viton (V)
FFKM perfluoroelastomeric (K),
Other…
MICROTEM SRL
Via Valdilocchi 6
19126 La Spezia (Sp)
Phone. +39.0187.984276
Fax. +39.0187.911318
Mail. info@microtem.it
P.IVA 01220300113
Accedi o registrati per visualizzare la scheda
The form was completed successfully.
You will be contacted as soon as possible.
Thank you.